car ZIL-131
Radiator tubular-ribbon, with oval-section tubes, four-row
Radiator filler cap (Fig. 1) is sealed with two valves; inlet (air) and outlet (steam)
The compressor is a piston type, non-straight-through, two-cylinder, single-stage compression
The clutch of the ZIL-131 car is single-disk, dry, installed in a cast iron housing 8
Installing the ignition during engine assembly, as well as on engines from which the distributor and distributor drive have been removed, must be done in the following order:
The vehicle is equipped with independent brakes — hand and foot
The hand brake is a shoe brake, drum type, with two inner shoes, installed on the transfer case
Oil is used to lubricate the engine; specified in the lubrication chart.
Check the oil level in the crankcase using the dipstick, which has three marks on it:
The cardan shaft has two joints. The cardan joint consists of needle bearings 4 installed in the forks and secured with retaining rings 2, and a crosspiece 3 inserted into the bearings
