repair Niva Chevrolet
The VAZ-2123 car controller is usually located in the passenger compartment on the right side under the glove compartment
If the engine cylinder head installed on the vehicle needs repair, remove it as described in the article "Replacing the Niva Chevrolet Cylinder Head Gasket"
The car uses direct current electrical equipment with a nominal voltage of 12 V
The starter type 5722.3708 is a DC motor with excitation from permanent magnets, combined with a planetary gearbox and an electromagnetic two-winding traction relay
You will need: a pipe (gas) wrench, a screwdriver, a chisel, a punch, a hammer, a universal joint puller, a snap ring puller, a wire brush, penetrating lubricant (for example, WD-40)
The ignition system uses a 4-pin ignition coil, which is a block of two 2-pin ignition coils
Wheel speed sensors generate signals about the speed of each wheel of the vehicle, which are transmitted to the electronic control unit of the hydraulic unit.
