The engine is in-line four-cylinder, equipped with an integrated microprocessor-based fuel injection and ignition control system (KMSUD)
General view and cross section of the engines are shown in the figures.
Inline four-cylinder engines equipped with carburetors and contactless ignition system.
The head of the block can be removed with the intake pipe and exhaust manifold. If the block head is removed from the engine installed on the car, you must first perform the following operations:
Oil change interval is 60,000 km
It is recommended to drain the oil immediately after the trip
Removal and installation of the GAZ-3110 steering linkage
Put the parking brake on.
Install rear wheel chocks.
Checking and replacing the ball joints of the GAZ-3110 steering linkage
Check the lateral play in the hinge. To do this, set the wheels in the position of driving the car in a straight line and shake the steering wheel in both directions
Removal and installation of the pendulum lever GAZ-3110
Put the parking brake on.
Install rear wheel chocks.
In the article, we will consider possible malfunctions of the steering and methods for their elimination
The car has a dual-circuit brake system
Scheme of the working brake system is shown in the figure
Diaphragm spring clutch
The clutch of the car is single-disc dry with a central diaphragm spring, hydraulically actuated
The master cylinder must be repaired or replaced when the pressure in the clutch release actuator is not maintained (when the pedal is pressed smoothly, the pedal reaches the stop, but the clutch does not disengage)