car MAZ

For repair, the starter is removed from the engine by unscrewing the bolts of the clamps

Disassembly of the starter should be done in the following order:

Thermal clearances in the valve mechanism are designed to ensure a tight fit of the valve on the seat when the valve drive parts expand during engine operation

To adjust the rear wheel bearings;

  • - raise the rear of the car;

Fuel priming pump (fig. 1). Piston type, mounted on high pressure pump and driven by camshaft eccentric

A schematic diagram of the pneumatic drive of brakes for three-axle vehicles is shown in Fig. 1, biaxial - in Fig. 2

All-mode, centrifugal type, changes the fuel supply depending on the load, maintaining the engine speed set by the driver

Removing the fan drive (see Fig. 1)

Remove the front harness bracket (2) (650.3724142) by unscrewing the fastening bolt and nut

Page 1 of 14