car ZIL-131
Power steering pump 1 with a reservoir is mounted on the engine and is driven through a pulley by a V-belt from a pulley located on the front end of the crankshaft
Design of contact ignition system ZIL 131
The engine is equipped with a shielded, sealed battery ignition system, consisting of a B 102-B ignition coil, a P102 ignition distributor, CH307 spark plugs and high voltage wires in shielding hoses and manifolds, as well as an ignition switch
The cardan shaft has two joints. The cardan joint consists of needle bearings 4 installed in the forks and secured with retaining rings 2, and a crosspiece 3 inserted into the bearings
The car is equipped with a winch designed to pull the car out when overcoming difficult sections of the road, as well as to provide assistance to other cars stuck on the way
The non-contact shielded ignition system is installed on the ZIL-1Z1 car and its modifications
The starting engine heater is designed to warm up the engine before starting it at low ambient temperatures
The vehicle's electrical system is single-wire, with a nominal voltage of 12 V; the negative terminals of the current sources are connected to the body ("vehicle ground")
