car ZIL-131
The engine cylinder block is cast iron, with insert liners made of gray cast iron with an acid-resistant insert in the upper part of the liner by clamping the liner collar between the block and the cylinder head through an asbestos steel gasket, and in the lower part by two rubber rings
Installing the ignition during engine assembly, as well as on engines from which the distributor and distributor drive have been removed, must be done in the following order:
The front suspension consists of two longitudinal semi-elliptical springs and two telescopic shock absorbers
Crankcase ventilation is forced, by sucking crankcase gases into the engine intake manifold through a special valve 3 installed on the intake manifold
The coupling head is used to connect the air ducts of the vehicle to the trailer
Axle design of the ZIL-131 car
The rear and middle axles of the car are driving.
Front axle - steered and driven
The starting engine heater is designed to warm up the engine before starting it at low ambient temperatures
