Crankcase ventilation is forced, by sucking crankcase gases into the engine intake manifold through a special valve 3 installed on the intake manifold
The vehicle is equipped with power steering, which is combined into a single unit with the steering gear
The starting engine heater is designed to warm up the engine before starting it at low ambient temperatures
The cardan shaft has two joints. The cardan joint consists of needle bearings 4 installed in the forks and secured with retaining rings 2, and a crosspiece 3 inserted into the bearings
ZIL-131 wheels, disc, with split rim and spacer ring, interchangeable, rim size 9.0 RG — 20
Tires of size 12.00—-20, adapted to work at variable pressure
The engine cylinder block is cast iron, with insert liners made of gray cast iron with an acid-resistant insert in the upper part of the liner by clamping the liner collar between the block and the cylinder head through an asbestos steel gasket, and in the lower part by two rubber rings
The safety valve is designed to protect the pneumatic system from excessive pressure increase in the event of damage to the automatic pressure regulator
