Adjusting the contact in the gears of ZIL-5301

Adjusting the contact patch in the main transmission gears of the ZIL-5301

After adjusting the main transmission bearings, it is necessary to check the engagement of the teeth of the driving and driven bevel gears (on the paint on the contact patch) and, if necessary, adjust the engagement and set the required gap between the teeth.

  1. Brake malfunctions ZIL-5301
  2. Features of the ZIL-5301 brake system
  3. Electrical diagram of ZIL-5301
  4. Assembly and installation of the ZIL-5301 clutch
  5. Maintenance of the ZIL-5301 heater
  6. Dismantling and disassembling the power unit D-245
  7. High pressure fuel accumulator D-245E3
  8. Rearrangement of the washer reservoir ZIL-5301
  9. Adjusting the boost corrector ZIL-5301
  10. Starting and stopping diesel engine D-245E3
  11. We remove the gearbox ZIL-5301
  12. Rear wheel brakes ZIL-5301
  13. High pressure fuel pump D-245E3
  14. Removal and disassembly of the cardan shaft ZIL-5301
  15. Diagnostics of the condition of the rear axle ZIL-5301
  16. Assembly and installation of the cardan shaft ZIL-5301
  17. Cooling system thermostat ZIL-5301
  18. Adjusting the bearing of the drive pinion ZIL-5301
  19. How to repair liquid pump D-245E3
  20. D-245 engine power system

Page 82 of 288