Repair of connecting rods comes down to replacing the upper head bushing and then processing it to fit a piston pin of a nominal size or to processing the bushing available in the connecting rod for a repair-size pin
The gas distribution mechanism requires periodic adjustment of the gaps between the rocker arms and valves, which should be performed on a cold engine after a mileage of 16,000 km
Restore the normal size of the gaps between the pads and brake drums and reduce the pedal stroke using eccentrics, in which the hexagonal heads of the axles are brought out through the shield
Fill the hydraulic drive with fluid and pump it to remove air in the following order:
Disconnect the wire from the negative terminal of the battery.
Install the piston of the 1st cylinder in the idle position. compression stroke.
Remove and disassemble the pressure regulator in the following order:
Disconnect the lines leading to the regulator.
Axles with final drives (Fig. 1 and 2) are installed as a complete set (front and rear) on modifications of vehicles of the UAZ-31512 family with simultaneous replacement of the rear propeller shaft
