ZIL-5301 engine coolant pump
The design of the liquid pump is shown in the figure.
The liquid pump body as an assembly must be tested with water under a pressure of 0.2±0.01 MPa for 2 min. In this case, no leaks or drops are allowed.
- Features of the ZIL-5301 brake system
- Assembly and installation of the fuel injection pump regulator ZIL-5301
- Design of the control output ZIL-5301
- Shock absorber assembly ZIL-5301
- Repair of heater ZIL-5301
- Rear hubs of the ZIL-5301 vehicle
- Checking the ZIL-5301 tie rod joints
- Maintenance of the fuel system D-245E3
- Maintenance of the ZIL-5301 heater
- Cylinder block, crank mechanism (requirements)
- Main brake cylinder ZIL-5301
- Air supply system of diesel engine ZIL-5301
- Removal and disassembly of the cardan shaft ZIL-5301
- Signaling device ZIL-5301
- Clutch master cylinder reservoir ZIL-5301 and its installation
- Layout of wire bundles and devices ZIL-5301
- Two-section brake valve ZIL-5301
- Diesel D-245 catalog
- Brake master cylinder ZIL-5301
- Pressure regulator ZIL-5301