The pressure regulator (Fig. 1) is designed for automatic regulation of pressure in the pneumatic system within 0.65 - 0.8 MPa, as well as for protecting pneumatic drive units from oil contamination and excessive pressure increase in the event of failure of the regulating device
- Hydraulic drive pressure regulator ZIL-5301
- Shaft and column ZIL-5301 disassembly
- Repair of heater ZIL-5301
- Assembly, installation of gearbox ZIL-5301
- Voltage regulator ZIL-5301
- Parking brake ZIL-5301
- Vibration when driving ZIL-5301
- ZIL-5301 springs assembly
- Maintenance of the fuel system D-245E3
- Installation of ZIL-5301 mechanisms and oil filling
- Scheme of the ZIL-5301 oil pressure gauge
- Injector D-245
- Adjusting the boost corrector ZIL-5301
- Drive axle ZIL-5301
- Operating experience ZIL-5301
- Lock and door handle ZIL-5301
- Half shaft housing and main gear of the rear axle ZIL-5301
- Wheels and tires ZIL-5301
- Installation of oil radiator ZIL-5301 engine
- Installation of hydraulic brake lines