Wheel speed sensor and ABS electronic unit ZIL-5301
Wheel speed sensors are designed to determine the angular velocity of the wheels and transmit a signal to the ABS electronic unit
When removing the gearbox, it is necessary to unscrew the bolts securing the cabin floor cover, remove it and unscrew the flange for fastening the cardan shaft
Adjusting the speed mode of the D-245
To adjust the speed mode of the high-pressure fuel pump, do the following:
The design of the front wheel service brakes is shown in Figure 1
Pneumatic brake chamber ZIL-5301
On ZIL-5301 vehicles with drive separation by axles and on ZIL buses, flangeless brake chambers are used, designed to act on the main brake cylinders and installed together with them on brackets
Maintenance of the heater is divided into the following types:
- - daily maintenance (DM);
Adjusting the thrust bearings of the ZIL-5301 steering gear
To adjust the bearings, do the following:
The quick release valve is designed to reduce the actuation time of the parking brake by accelerating the release of air from the energy accumulator by reducing the path traveled by compressed air and increasing the flow area during release
Synchronization of the crankshaft and fuel injection pump drive gearbox shaft pulse wheels D-245E3
The need to install (reinstall) the crankshaft and fuel injection pump drive gearbox shaft pulse wheels for their synchronization may be caused by dismantling the fuel injection pump drive gearbox during routine repairs of the diesel engine
The final drive can be adjusted or repaired without removing the rear axle from the vehicle
To check the condition of the steering rod joints, place the vehicle on a level horizontal surface so that the front wheels are straight ahead
The rear lights of the ZIL-5301 vehicle are combined, consisting of three sections (brake light, side light and direction indicators).
The fog light and reversing light are separate. Two license plate lights are mounted on the sides of the number.
Signaling device for a car with a brake drive divided on the sides
The device is located on the bracket of the left mudguard of the wing
The control output valve is needed to check the pressure using a pressure gauge, as well as to take off compressed air
The valves are installed in all circuits of the pneumatic brake drive of the car
Installing the flexible shaft of the ZIL-5301 speedometer according to the catalogue
The figure shows the installation locations of the parts and their designations according to the spare parts catalogue.
ZIL-5301 high-pressure fuel pump regulator
The figure shows the installation locations of the parts and their designations according to the spare parts catalog
Installation of fuel supply equipment ZIL-5301
The figure shows the installation locations of the parts and their designations according to the spare parts catalog
ZIL-5301 gearbox parts according to the catalog
The gearbox installed on the ZIL-5301 is a five-speed manual with synchronizers
The figure shows the installation locations of the parts and their designations according to the spare parts catalog.
We look at the figure and the table shows the decoding of the part.
ZIL-5301 cabin door
The figure shows the installation locations of the parts and their designations according to the spare parts catalog.
We look at the figure and the table shows the decoding of the part.