Based on operating experience, it is advisable to change the fine filter after 3-4 thousand km.
To replace the filter, we will need wrenches "13", "19", "17", a brush, a 1L container for draining fuel from the housing.
Diagnostics, testing and maintenance of brakes ZIL-5301
Checking the brake systems on the stand
Checking the service brake system is carried out on a roller brake stand with the engine running
Installing the connecting rod and piston group D-245
Check the conformity of the piston set size group and the cylinder liner size group
Installing the diesel support and crankshaft pulley D-245
ZIL-5301 Centrifugal Oil Filter
The design of the centrifugal oil filter is shown in Fig. 1
To assemble the shock absorber, you need to:
Install the compression valve body in a vice and secure the compression valve stem.
Adjustment of the D-245 boost corrector
The rod movement should begin when the air pressure in the above-diaphragm space is 0.005-0.010 MPa
Assembly of the 4UTNI-T-1111005-50 high-pressure fuel pump for the ZIL-5301 vehicle
Before assembly, the low-pressure cavity of the pump must be flushed with diesel fuel under a pressure of 1.8-2.0 MPa. filtered M10G2 motor oil should be used to lubricate the pump and regulator parts
Cylinder liners and cylinder block seating surfaces under the liners should be wiped with a napkin and blown with compressed air
Install the cylinder liners in the diesel block
The propeller shaft has two joints and a sliding spline connection.
The propeller shaft forks are attached to the steering screw and the steering column shaft with wedges.
The figure shows the installation locations of the parts and their designations according to the spare parts catalog.
We look at the figure and the table shows the decoding of the part.
ZIL-5301 high-pressure fuel pump according to the catalog
The figure shows the installation locations of the parts and their designations according to the spare parts catalog
ZIL-5301 Cabin Heater Catalog
The catalog details are shown in the figure, where you can see the number and find out the name of this part in the table
Air supply tract and oil lines of turbocharger ZIL-5301 catalog
The figure shows the installation locations of the parts and their designations according to the spare parts catalog.
We look at the figure and the table shows the decoding of the part.
Hydraulic drive pressure regulator on vehicles with split drive on the sides
The hydraulic drive brake force regulator is designed to adjust the brake fluid pressure when braking the vehicle, in order to prevent the rear wheels from locking when the vehicle is partially loaded
The figure shows the installation locations of the parts and their designations according to the spare parts catalog.
We look at the figure and the table shows the decoding of the part.
Installing the flexible shaft of the ZIL-5301 speedometer according to the catalogue
The figure shows the installation locations of the parts and their designations according to the spare parts catalogue.
The ZIL-5301 vehicle is equipped with a parking brake system with a drive from a spring energy accumulator.
The parking brake is activated by turning the valve handle to the extreme fixed position.
ZIL-5301 cardan transmission
The figure shows the installation locations of the parts and their designations according to the spare parts catalog
We look at the figure and the table shows the decoding of the part
The figure shows the installation locations of the parts and their designations according to the spare parts catalog