car UAZ-3151

Place the vehicle on a platform or inspection ditch to gain access from below to the gearbox and clutch

Transistor switch type 131.3734 or 90.3734 is installed on the car on the left mudguard behind the battery

Disconnect the wire from the negative terminal of the battery.
Install the piston of the 1st cylinder in the idle position. compression stroke.

The lubrication system diagram is shown in Fig. 1.
Oil pressure in the lubrication system of a warm engine at low crankshaft speed 550–650 min -1

During repairs, brake pads and wheel cylinders or parts included in them usually need to be replaced, for the removal of which there is no need to remove the entire brake mechanisms