Cylinder block

  • - it is not necessary to remove the engine to remove the cylinder head
  • - to prevent damage to the paintwork of the wings of the body, it is necessary to use a special coating
  • - to prevent damage to the cylinder head, before removing it, you must wait until the engine cools down

The fuel supply system ensures fuel purification and uniform distribution among the engine cylinders in metered portions and at strictly defined moments in time

The fuel supply system filters the fuel and distributes it evenly among the engine cylinders in metered portions at strictly defined moments

KAMA3-740.50-360, KAMA3-740.51-320 engines, designed for installation on single vehicles and truck tractors used as part of road trains, supplied to the domestic market and for export to countries with a moderate and tropical climate, as well as supplied as spare parts

Tightening torques for diesel connections of KamAZ vehicles

Name

Tightening conditions

Checking the tightening of the cylinder head mounting bolts

Check the tightening of the cylinder head mounting bolts after the break-in period and every 40 thousand km of run on a warmed-up diesel engine in the following order:

Carburetor K-151V (Fig. 1) - vertical, emulsion, two-chamber, with a falling mixture flow and sequential opening of the throttle valves

The GA3-66 vehicle is a two-axle truck, with a payload capacity of 2 tons, all-terrain, with drive on both axles. It is designed to replace the same type of GAZ-63 car produced by the plant

The clutch of the YaMZ-238 model is double-disc, dry, friction type, with a peripheral arrangement of cylindrical springs

Installing cylinder heads, valve rocker arms and adjusting valve clearances

The cylinder head mounting studs are screwed into the right and left rows of the cylinder block, having previously lubricated the threaded holes for the studs in the block with diesel oil

The engine consists of a crank and gas distribution mechanisms, as well as cooling, lubrication, power and control systems, and starting

Let's consider the malfunctions that may occur during engine operation:

  • - The crankshaft is not turned by the starter;

The YaMZ-236M2 and YaMZ-238M2 engines are six- and eight-cylinder models of the family of four-stroke diesel engines of Avtodizel OJSC

Cylinder block, drive units and characteristics of engines KAMAZ 740.11-240, 740.13-260, 740.14-300, 740.11-3902007 RE

Technical characteristics of engines 740.11-240, 740.13-260, 740.14-300

The cylinder heads are separate for each cylinder, made of aluminum alloy. They have water cavities communicating with the same cavities of the cylinder block, inlet and outlet channels, plug-in seats and valve guides.

Page 2 of 2