Removing the gearbox for repairs, for dismantling the engine
Preparing the car for removing the gearbox.
We remove the heater elements for inspection or replacement.
In the previous article, we looked at removing the heater control unit
In this article we will consider the removal and installation of tubes connecting the entire air conditioning system of the Lada Largus
We remove the steering wheel to replace it, as well as when dismantling the steering column switch connector, steering column or instrument panel
Install the car on a lift
Remove the crankcase guard and protective screen
In the previous article we looked at the beginning of disassembling the DPO automatic transmission. In this article, we will continue disassembling the transmission
Lada Largus cars are equipped with a steering system with a rack and pinion type steering mechanism and a hydraulic booster
Prepare the car for work. Disconnect the negative terminal of the battery
Removal
Remove the instrument panel.
The clutch of the Lada Largus car is single-plate, dry type
The possible cause of knocking in the front suspension may be the ball joints
Install and prepare the car for work
Remove the negative battery terminal.
Usually the heater is removed to replace the evaporator or to repair the heater
After removing the engine from the car and removing the cylinder head, you can begin disassembling, repairing and assembling the engine cylinder block
Anti-lock braking system provides more efficient braking of the car by reducing the fluid pressure in the brakes at the moment of their locking
Replacing the tie rod end
We replace the outer tie rod end if we detect play in the ball joint of the tie rod or damage to the joint boot
Most electrical circuits are protected by fuses. Powerful consumers are connected via relays
To improve the filling of the cylinders with fuel mixture in all modes, 1.6 l engines. equipped with a phase regulator of the intake valve camshaft
Bleeding (removing air) of the hydraulic system of the power steering is necessary after any work related to depressurization of the system (replacing the pump or pipelines)
We replace the replaceable element of the engine air filter during the next maintenance after 15 thousand km of run
It is advisable to check the fluid level in the expansion tank of the cooling system during each inspection of the car before leaving and necessarily in the event of engine overheating and the associated release of fluid from the system