
The design feature of the transmission with the JH3 gearbox is the approximation of equal length of the drives

Prepare the car for work. Disconnect the negative terminal of the battery
Removal
Remove the instrument panel.

Replacing the tie rod end
We replace the outer tie rod end if we detect play in the ball joint of the tie rod or damage to the joint boot

Engine removal was discussed in the article - "Removing the K7M engine"
Place the trolley with the engine and gearbox assembly under the car, which is raised on a lift.

Failure of the timing belt (breakage or shear of the teeth) will lead to the valves hitting the pistons due to the misalignment of the rotation angles of the crankshaft and camshaft and, as a result, to expensive engine repairs

This article describes the diagnostic procedure used for the air conditioning system of the LADA LARGUS car

We replace the master cylinder in case of the following faults:
- - incomplete release of all wheels (jamming of the master cylinder piston);

We remove the fuel rail to replace the injectors and to clean the fuel rail, as well as when repairing the cylinder head
We prepare the car for the work.

The hydraulic unit or hydraulic distributor, receiving signals from the electronic control unit, switches the channels in the control valve block and controls the clutch engagement pressure

The front passenger airbag is located in the instrument panel on the passenger side and consists of a folded airbag shell and a gas generator.

The heating (air conditioning) and ventilation system is a single complex that provides the most comfortable conditions in the car regardless of weather conditions and driving mode

You will need: the same tools as for replacing the valve stem seals, except for those that are needed directly for replacing them (tools are used only for preparatory operations),