How to remove bumpers of a Lada Largus car

: Also available:

Put the car on a lift or an inspection pit

Disconnect the negative terminal of the battery.

Removing the front bumper

Front bumper protective shield: 1 - self-tapping screw for lower bumper mount; 2 - lower protective shield; 3 - pin for fastening the shield to the bumper; 4 - the pin securing the shield to the subframe

To remove the front bumper, you need to remove the mudguard for this:

Using a slotted screwdriver, remove the pin 3 securing the shield to the mudguard.

Remove the pin 4 securing the shield to the subframe.

Using a TorxT20 head, unscrew the three screws 1 securing the lower bumper mount

Remove the lower mudguard 2.

Side bumper mount: 1 - bumper side mounting screw; 2 - bumper side mounting bolt; 3 - protective cover of the wheel arch

Using the TorxT20 head, unscrew the screws 1 of the side bumper mount on the right and left sides of the car.

Move the protective cover of the wheel arch aside and using the TorxT30 head, unscrew the bolts 2 of the side bumper mount on the right and left sides of the car

Lower bumper mount: 1 - bolt of the lower bumper mount to the subframe

Using the TorxT30 head, unscrew the bolts 1 lower bumper mount to the subframe

Upper bumper mount: 1 - screw for fastening the bumper to the upper crossmember of the radiator frame

Using a TorxT30 head, unscrew screws 1 for fastening the bumper to the upper crossmember of the radiator frame

If fog lights are installed and need to be removed, then:

Fog lamp: 1 - fog lamp; 2 - front bumper wiring harness connector

Disconnect the front bumper wiring harness connector from the wiring harness connector (as shown in the figure) of the instrument panel.

Remove the fog lights.

Remove the front bumper

Install the front bumper in the reverse order.

Removing the rear bumper

Carry out preparatory operations, disconnect the negative terminal of the battery.

Remove the taillights, see the article - "How to remove the taillights of a Lada Largus"

Side bumper mount: 1 - side bumper mount bolt; 2 - self-tapping screw for attaching the casing to the bumper; 3 - rear wheel arch protective cover

Using a TorxT20 screwdriver, unscrew two screws 2 securing the cover to the bumper on the right and left sides of the car.

Move the wheel arch protective cover aside and unscrew the bolts 1 securing the side bumper on the right and left sides of the car

Lower bumper mount: 1 - lower bumper mount screw

Using a TorxT30 head, unscrew the five screws 1 securing the lower mount bumpers

Rear bumper bracket: 1 - rear bumper side bracket

Disengage the bumper sides from the side brackets 1

Upper mount bumpers: 1 - upper bumper mounting bolt

Using a TorxT30 head, unscrew the eight bolts 1 of the bumper mounting.

Remove the rear bumper

Installation is carried out in the reverse order.