How to remove the headlight and turn signal repeater of the Lada Largus

: Also available:

Put the car on an inspection pit or on a lift

Remove the front bumper, article - "How to remove a car bumper"

Disconnect the battery.

Removing the headlight: 1, 3, 4 - headlight mounting bolts; 2 - headlight

Using a 10 mm socket, unscrew the three bolts 1, 3, 4 securing the headlight to the car body

Headlight: 1 - headlight; 2 - screw for adjusting the optical element in the horizontal plane; 3 - cover of the high and low beam lamp socket; 4 - sealing boot of the headlight corrector; 5 - lamp socket of the parking light and daytime running light; 6 - ground terminal of the front harness; 7 - direction indicator lamp socket

Remove cover 3 of the high and low beam lamp socket

Disconnect the lamp connectors.

Slide the sealing boot 4 of the headlight range adjuster along the cable sheath.

Removing the headlight range adjuster drive: 1 - headlight range adjuster drive; 2 - fastening latch; 3 - drive pusher; 4 - cable end; 5 - cable sheath end; 6 - sealing cover

Remove the headlight corrector actuator from the headlight housing (see below).

Remove the parking light bulb socket.

Remove the headlight.

Installing the headlight

Install the headlight in the reverse order of removal.

In this case, it is necessary to ensure uniformity of the gaps between the headlight and the mating parts of the car body.

If it is necessary to replace the headlight bulbs, remove the protective cap from the engine compartment side of the corresponding lamp, Figure 2, and replace the lamp.

Do not touch the halogen lamp bulb with your fingers.

Remaining grease marks can cause the lamp to overheat and explode when switched on.

In case of After touching the glass of the lamp, wipe it with a lint-free cloth. Replace the bulbs wearing clean cloth gloves.

Install the front bumper.

Adjust the direction of the headlights.

To remove the headlight corrector drive:

Disconnect cover 3, Figure 2, of the high and low beam lamp socket.

Move the sealing boot 6 along the cable sheath (Figure 3)

Press the latch 2 of the corrector housing and, turning it, remove the corrector housing from the headlight.

Press the pusher 3 of the drive so that a small gap is formed at the end of the cable 4.

Disconnect the end of the cable sheath 5.

Disconnect the cable from the drive.

Installing the corrector drive headlights

Pull reflector 1, figure 4, towards you so as to bring the slot in the holder as close as possible to the corrector pusher.

Installing the headlight corrector drive: 1 - reflector; 2 - holder

Fix the pusher in the slot of holder 2.

Secure the corrector drive with a clamp.

Install the tip 4, figure 3, of the corrector drive cable into the pusher.

Pull back and secure the tip of the cable sheath 5 in the corrector drive housing.

Install the sealing boot 6 in place.

Install the cover 3, figure 2, of the high and low beam lamp socket.

Removing the turn signal repeater

Install the car in the workplace.

Lift the hood, disconnect the ground wire terminal from the battery.

Removing the side turn signal: 1 - bulb socket; 2 - housing retainer; 3 - side turn signal housing

Press the two clamps 2 and remove the housing 3 of the turn signal repeater with the seal assembly from the front wing of the car

Replacing the lamp: 1 - lamp holder; 2 - lamp

Remove the holder 1 from the housing 3 of the turn signal repeater, turn it a quarter turn counterclockwise and pull the lamp 2 towards you

We install the side turn signal in the reverse order of removal.