Prepare the car for work. Disconnect the negative battery terminal.
Open the rear doors of the car.
Remove the mesh (if available when removing the rear light from the right wing).
Remove the jack (if available when removing the rear light from the right wing).
Unscrew the two nuts 1, 3, fastening the right or left rear light to the car body
Disconnect block 2, wiring harness rear from the right or left lamp.
Remove lamp 1 right or left
Press latches 2, remove the board from the taillight housing
To replace the taillight bulbs, turn the corresponding bulb counterclockwise, remove it and replace the bulb.
Check the operation of the bulb.
Installation
Install the taillight on the wing using the mounting pins.
Install the taillight in the reverse order of removal.
In this case, ensure that the light is sealed against the body.
Put the jack in place (when removing the right wing taillight).
Install the mesh (if available).