You will need: the same tools as for replacing the valve stem seals, except for those that are needed directly for replacing them (tools are used only for preparatory operations),
After removing the cylinder head, we disassemble it and inspect it for defects
The possible cause of knocking in the front suspension may be the ball joints
We remove the clutch discs when they are worn out and when replacing the rear crankshaft seal and flywheel, as well as when repairing the engine
If during the next maintenance or when changing a wheel it is found that the wear of the pads has exceeded the standards specified in the table, then it is necessary to change the pads
Install and prepare the car for work
Remove the negative battery terminal.
Prepare the vehicle for work. Disconnect the negative terminal of the battery.
