The piston pin is installed with tension in the upper head of the connecting rod and rotates freely in the piston bosses.

We replace the camshaft seals when repairing the cylinder head and when oil leaks from under the seal.

The design feature of the transmission with the JH3 gearbox is the approximation of equal length of the drives

To improve the filling of the cylinders with fuel mixture in all modes, 1.6 l engines. equipped with a phase regulator of the intake valve camshaft

Usually, replacing the gasket under the cylinder head cover is required if there are oil leaks in this area

Usually the steering column is removed for replacement when the column shaft bearings or intermediate shaft cardan joints fail

We replace the hub bearing when play appears. Bearing wear can be determined by increased noise when the car is moving

Prepare the car for work. Disconnect the negative battery terminal.

Open the rear doors of the car.

In this article, we will look at how to remove and install the windshield wiper trapezoids and motor reducers for the windshield and rear window

The evaporator is removed for replacement in case of malfunction.

The evaporator is installed in the heating and air conditioning system unit of the passenger compartment.

We remove the steering wheel to replace it, as well as when dismantling the steering column switch connector, steering column or instrument panel

Preparing the car for work. Disconnecting the negative battery terminal

Usually the exhaust manifold is removed to replace the gasket or for a complete engine overhaul

The piston pins are installed with tension in the upper heads of the connecting rods and rotate freely in the piston bosses, so heat the upper head of the connecting rod to a temperature of 250˚ C

Prepare the vehicle for work. Disconnect the negative terminal of the battery.