The ECU is the central device of the engine management system. The unit is fixed to the rear wall of the battery platform.

We remove the fuel rail to replace the injectors and to clean the fuel rail, as well as when repairing the cylinder head

We prepare the car for the work.

We replace the hub bearing when play appears. Bearing wear can be determined by increased noise when the car is moving

We replace shock absorbers in case of fluid leakage from shock absorbers, loss of functionality and presence of obvious defects.

Preparing the car for work. Install on a lift or in an inspection pit

Disconnect the negative terminal of the car battery.

Removing the engine was discussed in the article - "How to remove the K4M engine from a Lada Largus car"

The brake pads must be replaced as a set

Prepare the car for the work.

When performing work related to depressurization of the air conditioning system, it is necessary to completely unload the refrigerant and then load the system

Prepare the car for work. Disconnect the negative terminal of the battery

Removal

Remove the instrument panel.

If the inspection of the beam reveals breaks or swelling of the hinge rubber, both silent blocks must be replaced

Removing the gearbox for repairs, for dismantling the engine

Preparing the car for removing the gearbox.

Usually the exhaust manifold is removed to replace the gasket or for a complete engine overhaul

The heating (air conditioning) and ventilation system is a single complex that provides the most comfortable conditions in the car regardless of weather conditions and driving mode

We are replacing the gasket due to its burnout

Installing pistons with connecting rods

Lubricate the upper parts of the cylinders and the connecting rod journals of the crankshaft with engine oil.