If during the next maintenance or when changing a wheel it is found that the wear of the pads has exceeded the standards specified in the table, then it is necessary to change the pads
- How does the K4M engine phase regulator work?
- How to replace the alternator belt of a Lada Largus car with a K7M engine
- Interpretation of states, commands, parameters during diagnostics of the ECU Lada Largus
- How to remove the rear lights of a Lada Largus
- How to remove and install a thermostat for a K4M engine
- Bleeding and replacing hydraulic fluid in the steering system of Lada Largus
- Removal and installation of ABS units Lada Largus
- How to remove the throttle body of the K7M engine
- Removing the heating and air conditioning control unit of the Lada Largus
- How to disassemble the rear side doors of a Lada Largus
- How to remove the K7M engine from a Lada Largus
- How to Replace a Rear Wheel Hub Bearing on a Lada Largus
- How to remove and install the K4M engine pump
- Operating principle and repair of the hydraulic unit of the automatic transmission DPO (AL4)
- How to replace the brake master cylinder Lada Largus
- Operating principle and replacement of the ECU controller Lada Largus
- How to remove and install the fuel rail of the K7M engine
- How to replace the dust boots of the drive shafts of the wheels of Lada Largus
- How to Replace Rear Brake Pads Lada Largus
- The procedure for disassembling the cylinder block of the K4M engine