We remove the cylinder head to replace the cylinder head gasket
To compensate for thermal expansion of the valve relative to the valve lever, a gap between the end of the valve and the lever is structurally specified
We replace shock absorbers in case of fluid leakage from shock absorbers, loss of functionality and presence of obvious defects.
After removing the engine from the car and removing the cylinder head, you can begin disassembling, repairing and assembling the engine cylinder block
This article describes the diagnostic procedure used for the air conditioning system of the LADA LARGUS car
Install and prepare the car for work
Remove the negative battery terminal.
The compressor pulley is mounted on a double-row ball bearing.
When pressing out, the bearing is destroyed, so we press it out only for replacement
We remove and replace the supports if they are defective or when repairing the power unit
We install the car on a lift
For cars with air conditioning - we pump out the refrigerant from the air conditioning system
Remove the oxygen sensors if they fail and when dismantling the exhaust pipes
Removal of headlights, repeaters and taillights was discussed in the relevant articles
We replace the master cylinder in case of the following faults:
- - incomplete release of all wheels (jamming of the master cylinder piston);
The ignition system of the K4M engine consists of individual ignition coils and spark plugs for each cylinder.
Removing the engine was discussed in the article - "How to remove the K4M engine from a Lada Largus car"
Usually the heater is removed to replace the evaporator or to repair the heater
The air conditioner compressor provides circulation of the refrigerant in the system
The compressor shaft is mounted in the aluminum front housing cover on bearings and sealed on the drive pulley side with an oil seal
Remove the springs if they break, sag, replace the spring gaskets, remove the beam and remove the exhaust system (you have to remove the left spring)
