The piston pins are installed with tension in the upper heads of the connecting rods and rotate freely in the piston bosses, so heat the upper head of the connecting rod to a temperature of 250˚ C
- Disassembling the DPO automatic transmission (continued)
- Replacing the rear shock absorbers of a Lada Largus
- How to remove the intake manifold of the K7M engine
- Replacing the air filter of the K7M engine
- Cylinder block of the K4M engine
- How to remove the wheel drives from the gearbox JH3 Lada Largus
- How to replace the camshaft oil seal of the K7M engine
- How to remove the pan and replace the oil pump of the K7M engine
- How to replace the brake master cylinder Lada Largus
- How to replace the exhaust manifold gasket K7M Lada Largus
- How to assemble a JH3 gearbox
- Features of the brake design of Lada Largus
- How to replace the exhaust manifold gasket K4M
- How to clean the crankcase ventilation system of the K4M engine
- How to remove the throttle body of the K7M engine
- How to remove and install the front wing of a Lada Largus
- Interpretation of states, commands, parameters during diagnostics of the ECU Lada Largus
- ECU fault codes and troubleshooting for Lada Largus
- Design of drives with gearbox JH3 Lada Largus
- Replacing the timing belt of the K4M engine of the Lada Largus