car GAZ-3110
Disassembling the synchronizer
Check for the presence of aligned marks on the hub and sliding clutch of the synchronizer and, if not, mark them
Troubleshooting and repair of the GAZ-3110 cylinder block
To determine the technical condition and repair of the cylinder block, remove the engine from the vehicle (see "Removal and installation of ZMZ-406 GAZ-3110") and disassemble it.
Defection and repair of the GAZ-3110 cylinder block
Inspect the block, if there are cracks, replace it
Disconnect the wire from the negative terminal of the battery.
Repeaters of direction indicators GAZ-3110
Replacing the lamp
Disconnect the wire from the negative terminal of the battery.
Replacing the cylinder head gasket of the ZMZ-406 engine
The cylinder head gasket is replaced if it is damaged
Adjusting the installation angles and toe-in of the front wheels of the GAZ-3110
It is recommended to adjust wheel alignment angles on a stand at service stations. The adjustment should be made in the following sequence:
