Assembly procedure for the ZMZ-402 engine

• - clean all mating surfaces of the block from gaskets stuck and torn during disassembly;

Electrical diagram of GAZ-3110

Removing and disassembling the GAZ-3110 windshield wiper

Disconnect the wire from the negative terminal of the battery.

We replace the clutch when the driven and driving discs are worn

Install the car on an inspection ditch or lift

Open the cover of diagnostic connector 2 (Fig. 1) and close contacts 10 and 12 (technological jumper plug)

Defect elimination: The crankshaft is turned by the starter, but the engine does not start

First of all, you need to check and eliminate faults not related to the CMSUD:

Rolling bearings used on the GAZ-3110 car

Description (Part No.)

Cuff front crankshaft 53-1005034 404.1005034*

All parts of the connecting rod and piston group are divided into categories and individually selected for each other

It is not necessary for an experienced mechanic or locksmith to measure the tightening torque. With experience, he already feels it.

But sometimes on critical nodes you need to control yourself and use a torque wrench

Electric motor of the cooling system fan GPB 0 130 303 204 (engine ZMZ-4062) or 70.3730 (engine 3M3-402) - commutator, with excitation from permanent magnets

Fold up the edge of the luggage compartment mat, providing access to the fastening parts of the luggage compartment upholstery

It is more convenient to remove the front buffer if the car is raised on a lift or installed above an inspection ditch

Removing the hood

Using side cutters we pry up and remove the 14 pistons that secure the soundproofing lining to the hood

Before assembling the engine, all its parts must be cleaned of carbon deposits and tar deposits