Remove the steering column lining
Disconnect the wires from the brake light switch
To glue the windshield glass to the opening, use:
- adhesive-sealant “Terosat-8590” 1NU - ultra-viscous one-component black polyurethane-based sealant, characterized by a high rate of polymerization under the influence of air moisture with the formation of a rubber-like material
The cylinder block is cast from aluminum alloy and is integral with the upper part of the crankcase.
The block has a water jacket cavity that is open upward, into which cast iron sleeves are inserted with support in the bottom of this cavity
Adjusting the bearing clearance of the rear hub of the GAZ-2705
To adjust the bearings you need:
It is recommended to disassemble the engine in the following order:
The vehicle can be equipped with a solid beam axle or a rear banjo axle
In order for the rear axle gearbox to last longer you need:
Removal and installation of the throttle assembly of the ZMZ-40522, ZMZ-406 engine
Turning off the ignition, disconnect the negative terminal of the battery