car GAZ-2705
Repair of ignition distributor GAZ-2705
Disconnect the wire from the negative terminal of the battery.
Install the piston of the 1st cylinder in the idle position. compression stroke
On cars with a ZMZ-406 engine, a starter 42.3708-10 is installed on the clutch housing on the right side, and with a ZMZ-402 engine - ST230-B4 - on the left side of the clutch housing
The front axle is removed from the car in the following sequence:
- - loosen the wheel nuts
Main brake cylinder GAZ-2705 removal and repair
The main brake cylinder with two successive pistons 10 and 17 and a two-section reservoir 4 with sensor 6 for an emergency brake fluid level drop indicator is attached to the cover of the vacuum booster
Removing the window regulator
Remove the door trim (see the article - “How to remove the trim and front door lock of a Gazelle car”)
The rear suspension is made on two longitudinal leaf springs with two hydraulic shock absorbers
In order to remove the fender, you must first remove the front turn signal, turn signal and bumper
You don’t have to remove the bumper, just detach its side part.
