Engine lubrication system - combined: under pressure and splash
The speed and timing sensor is located at the front of the engine on the right side
Using the sensor signal, the engine control unit determines the angular position of the crankshaft and its rotation speed
After the first 2500 km and during maintenance-2, and also if the rear wheels of a loaded vehicle lock up earlier than the front wheels or much later when braking on a dry hard surface, you should make sure that the regulator is adjusted correctly
Adjusting the position of the steering column must be done after adjusting the driver's seat relative to the control pedals. To do this you need:
Removal and installation of the throttle assembly of the ZMZ-40522, ZMZ-406 engine
Turning off the ignition, disconnect the negative terminal of the battery
It is recommended to change the gearbox oil after 60 thousand kilometers of the vehicle, and check the level every 20 thousand km
The car has a rigid rear axle in the form of a beam, consisting of a main gear housing and axle housings pressed into it
The electrical equipment of the Gazelle vehicle is implemented according to a single-wire scheme: the negative terminals of the power sources and consumers are connected to the "ground" - the body and other units of the vehicle, which act as the second wire.
Main main gear malfunctions:
- - The rear axle gearbox bearings are worn out, their preload is broken, the fit is loose (uniform noise from the rear axle)
A typical electrical circuit may include a main electrical element, various switches, relays, electric motors, fuses, fuse links or circuit breakers, wiring and contact connectors related to this element, which serve to connect the main element to the battery and the body "ground"
Disassembling the gearbox synchronizer
Check for the presence of aligned marks on the hub and sliding clutch of the synchronizer and, if not, mark them.
The intermediate shaft drives the oil pump. In addition, camshafts are driven through it
Checking the removed shock absorber
Install the shock absorber in a vertical position
The front axle is removed from the car in the following sequence:
- - loosen the wheel nuts
The cooling system is liquid, closed, with forced circulation, consists of a water jacket in the engine block and cylinder head, a coolant pump, a radiator, an expansion tank, a fan, a thermostat, an expansion tank plug, a fan casing, a drain valve and a plug.
If, when braking the car with the parking brake, lever 1 (see Fig. 1) with a force of 600 N (60 kgf) or more applied to it is fixed on the uppermost teeth of the sector, then the drive should be adjusted in the following order:
