Repair ZIL-5301
Installing the steering gear of the ZIL-5301 vehicle
Install the steering gear with hydraulic booster on the frame using the KZ-0352 device and secure it with bolts
Assembly and installation of the ZIL-5301 gearbox
Assembly and installation of the intermediate shaft
Install key 8 in the shaft grooves and sequentially press the second gear pinion (0.005-0.055 mm interference), reverse gear (fit from 0.04 mm interference to 0.01 mm clearance), third and fourth gear pinions (0.015-0.065 mm interference), pre-selected by journals, onto the shaft.
Installing the rear sheet, cuff housing and flywheel of the D-245 crankshaft
The rear sheet should fit tightly on the pins pressed into the cylinder block
The front and rear suspension of the car are equipped with two hydraulic telescopic shock absorbers.
Rear wheel brake mechanisms ZIL-5301
Rear wheel brake mechanisms are shoe-type, drum-type. The brake mechanism design is shown in Fig. 1
To install the winch, you need to weld a frame from a channel or angle of this type
On the frame, we install a shaft with bearings for the cable and guides for the cable
When removing the clutch from the vehicle, it is necessary to disconnect the clutch release drive. This work can be performed both with and without disconnecting the pipelines
