car GAZ-2705
If, when braking the car with the parking brake, lever 1 (see Fig. 1) with a force of 600 N (60 kgf) or more applied to it is fixed on the uppermost teeth of the sector, then the drive should be adjusted in the following order:
Removing the steering mechanism
To do this you need to do the following:
Removal and inspection of the driveshaft was discussed in the article - “How to remove the driveshaft of a Gazelle car”
Design features are discussed in the article - “Design and malfunctions of the driveshaft of a Gazelle car”
Repair of ignition distributor GAZ-2705
Disconnect the wire from the negative terminal of the battery.
Install the piston of the 1st cylinder in the idle position. compression stroke
Beam 15 of the front suspension is stamped, I-section, connected to the steering knuckles using pins
We remove the rear wheel axle shafts to replace or adjust the rear axle gearbox or to remove the rear wheel hubs
We work together on the inspection ditch
Jack up the beam and remove the front wheel.
