Removing clutch discs of a car with an engine model ZMZ-405, ZMZ-406
Remove the clutch housing (see article - Removing the clutch housing (ZMZ-406 engine)
The water pump is a centrifugal type, with an electromagnetic clutch for the fan drive, installed on the chain cover, the pump supplies coolant to the cylinder block
The exhaust system consists of an exhaust manifold, exhaust pipes connected by a gas receiver, a resonator, an intermediate pipe, a muffler and an exhaust pipe
In the fuel injection engine power system, the pressure is 30 MPa (3 kgf/cm 2).
Therefore, it is forbidden to loosen the connections of the fuel lines while the engine is running or immediately after stopping it
Repair of ignition distributor GAZ-2705
Disconnect the wire from the negative terminal of the battery.
Install the piston of the 1st cylinder in the idle position. compression stroke
The electrical equipment of the Gazelle vehicle is implemented according to a single-wire scheme: the negative terminals of the power sources and consumers are connected to the "ground" - the body and other units of the vehicle, which act as the second wire.
Removal and installation of the crankshaft ZMZ-402 of the GAZ-2705
Remove the oil pan and crankcase gasket.
Remove the oil pump.
