Be sure to often look into the manual for the design, operation, maintenance and repair of the car, the catalog of spare parts in order to better understand your car, choose what you can do yourself, control the timing of mandatory maintenance, find out the details of the units

The vehicle is equipped with a rear axle with a stamped-welded banjo-type crankcase with a separately mounted gearbox

The technical condition of the steering can be approximately determined by the amount of free play (play) of the steering wheel

A pressure reducing valve is a container separated by a diaphragm on which a valve is attached that closes the fuel drain hole under the action of a spring

With the engine running and the vacuum booster in working order, the brake pedal when braking should not reach the floor of the cabin - the gap between the pedal and the floor should be at least 40 mm

Disconnect the wire from the negative terminal of the battery

Disconnect the accelerator cable from the throttle sector

Brake light switch

The brake light switch is installed on the side of the brake pedal

Electrical equipment diagram of GAZ-3302 and GAZ-2705 cars with ZMZ-406 engines

Scheme GAZ 2705

Checking the technical condition of the steering

Rotate the steering wheel to set the front wheels to the straight-ahead position

Removal, repair and installation of oil pump GAZ-2705

Drain the oil from the engine crankcase

Remove the oil sump

If, when braking the car with the parking brake, lever 1 (see Fig. 1) with a force of 600 N (60 kgf) or more applied to it is fixed on the uppermost teeth of the sector, then the drive should be adjusted in the following order:

On the ZMZ-40522 and ZMZ-40524 engines, a catalytic converter is installed in the exhaust gas system

Electrical equipment of GAZ-3302 and GAZ-2705 cars with ZMZ-405 engine

Symbols for electrical circuit elements:

The generator is the power plant of your car. When the engine is running, it supplies all electrical units with current and charges the battery

The parking brake should hold the vehicle on a 25% grade when the parking brake lever is moved 15-20 teeth (clicks) of the ratchet device

Drain the hydraulic fluid from the hydraulic drive, look - How to pump and replace the hydraulic clutch fluid of a gazelle

To troubleshoot, replace parts and assemblies, the suspension is subjected to complete or partial disassembly

Removing springs from the car

The general view and cross-section of the engines are shown in the figures.

The engines are in-line four-cylinder, equipped with carburetors and a contactless ignition system.