Locks are used to hold doors in a closed position while driving, in a parking lot, and in the event of a traffic accident
The main brake cylinder, with two sequential pistons 10 and 17 and a two-section reservoir 4 with sensor 6 for an emergency brake fluid level drop indicator, is attached to the cover of the vacuum booster
In a car cabin with three rows of seats, an additional heater is located on the floor behind the passenger seat (or under it)
Press ball bearings 1 and, if necessary, pressed-on gear rings from the intermediate shaft
Install the secondary shaft in a vertical position
Remove retaining ring 1 and spring ring 2 of the 3rd and 4th gear synchronizer
We replace brake pads simultaneously on both front wheels of the car by reducing the thickness of the linings to 3 mm
The control unit has a self-diagnosis mode, which can be used to determine faults in the system.
The cylinder block is cast from aluminum alloy and is integral with the upper part of the crankcase.
The block has a water jacket cavity that is open upward, into which cast iron sleeves are inserted with support in the bottom of this cavity
Heating is provided by air heated in heater radiators.
Outside air enters the main heater through a grille located between the windshield and the hood
Usually the sheathing and top panel are removed to remove the radiator, to replace the generator drive belts, and also to access other parts of the power plant
During the operation of the gearbox, some unpleasant defects may occur, which are directly related to how maintenance is carried out and the driver’s driving style
Checking the GAZ-2705 switch
Transistor switch type 131.3734 or 90.3734 is installed on the car on the left mudguard behind the battery
Closed liquid cooling system with forced circulation of liquid
Replacing the cylinder head cover gasket ZMZ-406 GAZ-2705
Over time, during operation, the gasket under the engine head cover loses its elasticity and strength and oil leaks from under the cover
Removal and installation of the flywheel ZMZ 406 GAZ-2705
The flywheel is removed to replace the rear crankshaft oil seal, to replace it if the toothed rim used to start the engine with the starter is damaged, and to grind the surface under the clutch driven disc
Replacement of exhaust pipes with engines ZMZ-4025, ZMZ-4061, 4026, ZMZ-4063
It is more convenient to work together on an inspection ditch or a lift.
Defection and repair of the ZMZ-402 cylinder block of the GAZ-2705
Inspect the block, if there are cracks, replace it
Cooling system ZMZ-40524 - liquid, closed, with forced circulation of coolant
Removing the bridge from the vehicle must be done in the following sequence:
- - loosen the rear wheel nuts;
In this article we will look at the exhaust gas recirculation system, the exhaust system and the engine mount