
Removal and installation of the flywheel ZMZ 406 GAZ-2705
The flywheel is removed to replace the rear crankshaft oil seal, to replace it if the toothed rim used to start the engine with the starter is damaged, and to grind the surface under the clutch driven disc

Defection and repair of the ZMZ-402 cylinder block of the GAZ-2705
Inspect the block, if there are cracks, replace it

Removing the bridge from the vehicle must be done in the following sequence:
- - loosen the rear wheel nuts;

In this article we will look at the exhaust gas recirculation system, the exhaust system and the engine mount

An ignition coil is a transformer, on the iron core of which a secondary winding is wound, and on top of it is a primary winding

The head is cast from aluminum alloy AK6M2.
There are additional racks for fastening the rocker arm axle

Lever-type clutch - dry, single-plate, consists of a housing assembly with a pressure plate, a clutch release lever, support forks, springs and a driven disk assembly with friction linings

Engine lubrication system - combined: under pressure and splash
The lubrication system diagram is shown in the figure

Some types of gazelles use an additional sediment filter.
The sediment filter needs to be washed after 5,000 kilometers of the car, taking into account that you refuel at good gas stations.

The car is equipped with an electric windshield wiper with two blades.
The electric windshield wiper motor with gearbox and drive lever system is located in the engine compartment

The generator works in conjunction with a contactless transistor voltage regulator 13.3702-01
Voltage regulator 50.3702 can be installed on some vehicles

Combined lubrication system, pressure and splash
The lubrication system diagram is shown in the figure

Remove the heater valve if a coolant leak appears
We remove the electric pump of the additional heater to access the tap during replacement, and if the pump itself malfunctions

The nozzle is an electromechanical valve in which the shut-off valve needle is pressed to the seat by a spring

Electrical equipment failures are often explained by simple reasons, such as corrosion of connector contacts, failure of a fuse, burnt-out fuse link or damaged relay