The cooling system is liquid, closed, with forced circulation, consists of a water jacket in the engine block and cylinder head, a coolant pump, a radiator, an expansion tank, a fan, a thermostat, an expansion tank plug, a fan casing, a drain valve and a plug.
If, when braking the car with the parking brake, lever 1 (see Fig. 1) with a force of 600 N (60 kgf) or more applied to it is fixed on the uppermost teeth of the sector, then the drive should be adjusted in the following order:
The direction the vehicle is turning is indicated by flashing lights in the front and rear turn signals
Removing the steering mechanism
To do this you need to do the following:
We replace the oil in the gearbox after 20-30 thousand kilometers.
We change the oil after the trip, while it is warmed up and has increased fluidity
We discussed dismantling the axle gearbox in the article - How to disassemble the rear axle of a Gazelle car
In this article we will look at how to properly assemble and adjust the rear axle gearbox of a Gazelle car.
Electrical equipment failures are often explained by simple reasons, such as corrosion of connector contacts, failure of a fuse, burnt-out fuse link or damaged relay
Replace the throttle cable if it is stuck or broken
Electrical equipment is made according to a single-wire circuit: the negative terminals of sources and consumers of electricity are connected to the “ground” - the body and main components of the car, which serve as the second wire
The frequency of oil changes is 60 thousand km
It is recommended to drain the oil immediately after the trip
Remove the cylinder head
Remove the crankcase and crankcase gasket
Dynamic properties and driving safety depend on how reliably the wheels are directed in the required direction
In this article we will look at the exhaust gas recirculation system, the exhaust system and the engine mount
Removal of the pressure regulator from the car and its repair are carried out if adjustment cannot achieve its correct operation
To remove the regulator you must:
Brake light switch
The brake light switch is installed on the side of the brake pedal
The fluid in the clutch system needs to be replaced after 2 years
We pump the hydraulic drive when replacing the working fluid, as well as to remove air from the system that has entered it during the repair or replacement of individual components
Checking electrical circuits
To measure electrical parameters, a digital or analog (arrow) tester is used - a voltmeter, ohmmeter and other devices combined in one housing
