To check the condition of the suspension ball joint, remove the wheel and measure the distance “A” between the lower arm 29 and the brake disc 9
The front suspension arm is replaced if the geometry of the arm is broken (the arm is bent), the rubber-metal hinges are torn, swollen on one side, or their rubber has lost its elasticity
Turn off the ignition and disconnect the engine management system wiring harness block from the sensor
The car is equipped with two braking systems - working and parking
With the ignition off, disconnect the wiring harness block of the engine management system of the mass flow sensor
We carry out a compression test for a general assessment of the technical condition of the parts of the cylinder-piston group and the engine valve mechanism
Disconnect the ground wire from the battery.
Use your fingers to press the horn switch cover
With the ignition off, disconnect the engine management system wiring harness block from the coolant temperature sensor
Before removing any sensor or engine control unit, you need to disconnect the negative terminal of the battery.
In order to change the backlight bulbs or to remove the instrument panel trim, and for other repair work, you need to remove the instrument panel
Usually the bracket and brace are changed after they are deformed as a result of shock loads that occur during emergency situations or during operation on bad roads
If, when the engine is running, a strong noise of a rotating bearing is heard in the area under the front timing belt covers, you should check the condition of the tension roller and replace it if necessary
The fuel module is a housing made of special plastic, in which are mounted: an electric submersible fuel pump, a strainer, a fuel pressure regulator and a fuel consumption indicator sensor
Replace the solenoid or check if reverse gear does not engage
We set the wheels to the position of straight-line movement of the car
Disconnect the terminal of the negative terminal wire of the battery
If the master cylinder piston jams (due to corrosion, breakage of the return springs), incomplete release of the brakes on all wheels may occur
Seats are usually removed for cleaning the interior and the seats themselves, as well as for better access to the components and parts of the instrument panel and vehicle controls
To ensure good stability and controllability of the car, the front wheels are installed at certain angles relative to the body and suspension elements
Removing the panel trim
We remove the panel lining in cases of replacing the wiring harness, as well as replacing ventilation and heating control rods