In order to change the backlight bulbs or to remove the instrument panel trim, and for other repair work, you need to remove the instrument panel
First of all, disconnect the negative terminal from the battery.
Release the steering column position adjustment lever and move the steering wheel as far down as possible.
Use a short Phillips screwdriver to unscrew the two self-tapping screws securing the instrument panel trim.
The lower protrusions of the cladding are equipped with spring clips, so you need to apply a little force to remove the cladding
Remove the trim from the instrument panel opening.
Use a Phillips screwdriver to unscrew the two screws securing the instrument panel
Remove the shield from the instrument panel
Having released the lock using a screwdriver, disconnect the wiring harness block from the shield.
Remove the instrument panel.
To remove the glass, use a screwdriver or hand to press the six plastic latches one by one and remove the glass.
To replace instrument backlight bulbs, use pliers to turn the protruding part of the faulty lamp socket counterclockwise and remove the socket with the light bulb from the instrument panel.
To replace the display backlight lamp, turn the lamp socket with an 8 mm socket wrench.
Install the socket with the lamp into the shield and turn it clockwise until it is completely fixed
The LED indicators installed in the instrument cluster are soldered into the board and cannot be replaced. Therefore, if the signaling device fails, you should replace the instrument cluster with a new one.
Assembling everything in reverse order