To determine the destruction of the bearing, you need to jack up the car from the side being tested until the wheel lifts off the road
Disassembling the gearbox input shaft
The dismantling of shafts is discussed in the article - “Repair of the gearbox of a Lada Kalina”
Clamp the input shaft in a vice with soft metal jaw linings.
We carry out the work on an inspection ditch or overpass with an empty tank
We carry out the work with an assistant. You can do without an assistant, but you will need a height-adjustable stop or stand
Removing the engine screen
Relieving pressure in the power system
Lada Kalina is a five-seater passenger car with a front engine, an all-metal welded body of a supporting structure, and front-wheel drive
Structurally, the windshield wiper of a Lada Kalina car consists of an electric motor, levers, brushes and hinges
We remove the trunk lock for replacement or repair
It is convenient to carry out the work in an inspection ditch. But if necessary, you can remove and install the spring and shock absorber of the rear suspension by placing the car on a flat horizontal platform
We carry out the work with an assistant on an inspection ditch or overpass
Draining the oil from the gearbox
The throttle position sensor is mounted on the side of the throttle assembly and is connected to the throttle shaft
To check the vacuum booster on a car, press the brake pedal 5-6 times
The rear suspension of the car is semi-independent, made on an elastic beam with trailing arms, coil springs and double-acting telescopic shock absorbers
Turn off the ignition and disconnect the engine control system wiring harness block from the coil
We carry out the work in an inspection pit or on a lift
From the bottom of the car, using a 13 mm spanner, loosen the tightening of the nut of the coupling bolt of the clamp securing the control rod to the shank of the gear selector rod hinge (Fig. 1)
Some drivers, trying to wear out the parking brake cable less, try to use it less often
We remove and repair the shock absorber strut when the upper support, bearing, spring and the telescopic strut itself are worn out
Remove the front wheel from the side of the tie rod end being replaced
Turn the steering wheel all the way in the direction opposite to the tip being removed
A starter type 5702.3708 is installed on the Lada Kalina.
Some cars may have a BOSH 0001108203 starter installed.
When we replace the generator belt or when repairing the engine, it is necessary to check the condition of the generator tensioner roller
The front brake mechanism is disc, ventilated, with a floating caliper and one working cylinder