car GAZ-2705

Also available:

The intake system consists of an intake pipe and a receiver cast from aluminum alloy

The geometric parameters of the system make it possible to implement gas-dynamic supercharging of the engine - improving the filling of the engine cylinders at a certain operating mode

Also available:

The cylinder block is cast from aluminum alloy and is integral with the upper part of the crankcase.

The block has a water jacket cavity that is open upward, into which cast iron sleeves are inserted with support in the bottom of this cavity

Also available:

Pistons are cast from high-silicon aluminum alloy and heat treated

Also available:

Remove the locking ring if it remains on the input shaft

Remove the bulk rollers (14 pcs.) of the front bearing of the secondary shaft, if this has not been done previously

Also available:

Adjusting the position of the steering column must be done after adjusting the driver's seat relative to the control pedals. To do this you need: