Replacing the rubber bushings of the lower arms of the GAZ-3110

Install the car on a lift or inspection ditch

Replacing the threaded joints of the front suspension strut of the GAZ-3110

Install the car on a lift or inspection ditch

Adjusting the installation angles and toe-in of the front wheels of the GAZ-3110

It is recommended to adjust wheel alignment angles on a stand at service stations. The adjustment should be made in the following sequence:

Removing and disassembling the front wheel hub of GAZ-3110

Place the car on the parking brake

Checking and replacing the shock absorber GAZ-3110

Remove the corresponding wheel

Install the car on a lift or inspection ditch

When checking the suspension, make sure that the suspension parts are not cracked or rubbed against road obstacles or the body

Place the vehicle on the parking brake.

Install stands for the rear wheels.

Raise the front of the car and place it on supports.

Replacement of the fuel pump of a GAZ-3110 car with a ZMZ-406 engine

The car has two independent braking systems: service and parking

Removing and installing the GAZ-3110 brake pedal

Remove the brake pedal to replace plastic bushings or for other work

The front wheel brakes are disc, with a single-piston floating caliper (when braking, the piston presses the inner pad to the disc, and the caliper, moving in the opposite direction, presses the outer pad).

The rear wheel brakes are drum brakes, with two-piston wheel cylinders with automatic adjustment of the gap between the shoes and the drum

Removal and installation of brake pressure regulator GAZ-3110

The pressure regulator is attached with two bolts to a bracket in the rear of the body

Parking brake system drive – mechanical, cable, to the rear wheels