To hold the hood in the closed position when the car is moving, use a pin-type hood lock 9, which is attached to the top panel of the radiator
The Gazelle car heater consists of a plastic casing in which a radiator, two fans mounted on the electric motor shaft, upper, central and lower dampers and a control panel with three levers and switches are installed
The idle speed controller serves to maintain the set idle speed of the engine unchanged when it is started, warmed up and load changes caused by the inclusion of auxiliary equipment
Place a container for used oil under the engine crankcase
Unscrew the plug and drain the oil from the crankcase
Rubber-metal hinges and rubber cushions must be replaced in case of ruptures and one-sided bulging of rubber, as well as when their end surfaces are trimmed
UMZ-4215 engines have a traditional design, which has been produced by Volzhskie Motors OJSC for a long time
Remove the locking ring if it remains on the input shaft
Remove the bulk rollers (14 pcs.) of the front bearing of the secondary shaft, if this has not been done previously
