Prepare the car for work.

Place the car on an inspection pit or lift. Disconnect the negative battery terminal.

The engine cooling system of the Lada Vesta is closed type under pressure.

There is a safety valve in the expansion tank cap.

Remove the supports if they are worn out or when dismantling the powertrain units

Exhaust gases are discharged from the engine through the exhaust pipe of the muffler with the neutralizer assembly, the additional muffler and the main muffler

We remove the ramp to check the injectors and flush the ramp itself, as well as to repair the engine and its systems

Prepare the car for work.

Place the car on a lift or in an inspection pit.

Prepare the car for work. Install it on a lift or in an inspection pit. Disconnect the negative battery terminal.

Change the tension roller if extraneous noise appears when it rotates

Replacing the generator drive belt of the Lada Vesta with a VAZ-21129 engine

We remove the belt for its replacement or for work related to the replacement of drive units, as well as when replacing the timing belt

Removing the heating and air conditioning unit

Prepare the car, open the hood and disconnect the negative battery terminal.

Prepare the car for work, disconnect the negative terminal of the battery.

Removing the front seat

Preparing the car for work

Removing the windshield trim

The windshield pillar trim is secured with three plastic holders

Put the car on a lift, turn off the ignition.

To dismantle the engine fuel system, you need to bleed the pressure in the fuel system, for this:

Fuel from the tank, which is located in the rear of the car near the rear seats, is supplied through tubes and hoses to the engine fuel injection system by means of an electric fuel pump module.

The model and number of the car, engine model, weight data, spare parts number, design options and configurations are indicated in the summary plate of the factory data, located on the right pillar, at the bottom, near the threshold