car ZIL-131
The tapered roller bearings of the drive bevel gear shaft of the gearbox are adjusted with a slight preload; axial clearance is not allowed
Adjusting the kingpin bearings
The kingpin bearings of the front drive axle steering knuckle are adjusted with a preliminary load
The gearbox is mechanical, three-speed, has five gears for moving forward and one for moving backward
Steering malfunctions do not always depend on its condition, and are sometimes caused by other reasons
The engine cylinder block is cast iron, with insert liners made of gray cast iron with an acid-resistant insert in the upper part of the liner by clamping the liner collar between the block and the cylinder head through an asbestos steel gasket, and in the lower part by two rubber rings
The pressure regulator is installed on the compressor cylinder block. To increase the reliability of the pressure regulator, it is equipped with two filters:
Power steering pump 1 with a reservoir is mounted on the engine and is driven through a pulley by a V-belt from a pulley located on the front end of the crankshaft
