Niva Chevrolet repair

Master cylinder (Fig. 1) with sequential piston arrangement

We remove the unit to replace the failed damper drive rods and backlight bulbs

The oil pan protection panel, made of thick sheet steel, serves to protect the crankcase from damage when the front of the car hits road obstacles.

It is recommended to change the oil in the front and rear axle gearboxes every 45 thousand km

The axle shaft assembly with the bearing is replaced if there is increased noise from the rear wheels of the vehicle compared to normal noise both when driving straight and when turning.

In this case, there is increased axial and radial play of the axle shaft

Starter type 5722.3708 (Fig. 1) is a DC electric motor with excitation from permanent magnets, combined with a planetary gearbox and an electromagnetic two-winding traction relay

If the gasket between the flanges of the receiver and the intake pipe is damaged, normal engine operation cannot be achieved, since the additional air sucked into the intake pipe does not allow the engine management system to provide the optimal composition of the combustible mixture required for each engine operating mode.

The operating principle of an air conditioner is almost the same as that of a home refrigerator

The condition of the belt tension rollers should always be checked when removing or replacing the drive belt

You will need: a hex key for the drain plug (usually this key is included with the car in the driver's tool kit), a special key for unscrewing the oil filter or a large screwdriver, a funnel, a clean rag.