Lada Granta repair
Usually the ignition switch is removed to replace it, as well as to replace the contact group of the switch or the APS coil
Remove the gearbox (see “Removing and installing the Lada Granta gearbox”)
We clean the outside of it from dirt (do not allow dirt to get inside the box)
Removing the speed sensor
Disassembling the gearbox input shaft
The dismantling of the shafts is discussed in the article - “Disassembling and assembling the Lada Granta gearbox”
Clamp the input shaft in a vice with soft metal jaw linings.
We carry out the work with an assistant on an inspection ditch or overpass
Draining the oil from the gearbox
Disconnect the wire terminal from the negative terminal of the battery
Replace the solenoid or check if reverse gear does not engage
We carry out the work on a lift or inspection pit
In this article we will look at disassembling the rear door of a car
Knock sensor - piezoelectric, reacts to engine vibration