To make sure that the voltage regulator is working properly, turn off all consumers except the high beam headlights and measure the voltage at the battery terminals

Removing the ramp and injectors of the Lada Granta engine

We remove the ramp and fuel injectors to check cleaning, replacement, and also when removing the intake pipe

Usually the ignition switch is removed to replace it, as well as to replace the contact group of the switch or the APS coil

Remove the gearbox (see “Removing and installing the Lada Granta gearbox”)

We clean the outside of it from dirt (do not allow dirt to get inside the box)

Removing the speed sensor

Disassembling the gearbox input shaft

The dismantling of the shafts is discussed in the article - “Disassembling and assembling the Lada Granta gearbox”

Clamp the input shaft in a vice with soft metal jaw linings.

We carry out the work with an assistant on an inspection ditch or overpass

Draining the oil from the gearbox

Disconnect the wire terminal from the negative terminal of the battery