The ZMZ-40524.10 engine is a modification of the ZMZ-40522.10 engine in order to meet Euro3 toxicity standards and increase its reliability and service life

Removing clutch discs of a car with an engine model ZMZ-405, ZMZ-406

Remove the clutch housing (see article - Removing the clutch housing (ZMZ-406 engine)

The water pump is a centrifugal type, with an electromagnetic clutch for the fan drive, installed on the chain cover, the pump supplies coolant to the cylinder block

The exhaust system consists of an exhaust manifold, exhaust pipes connected by a gas receiver, a resonator, an intermediate pipe, a muffler and an exhaust pipe

In the fuel injection engine power system, the pressure is 30 MPa (3 kgf/cm ²).

Therefore, it is forbidden to loosen the connections of the fuel lines while the engine is running or immediately after stopping it

Repair of ignition distributor GAZ-2705

Disconnect the wire from the negative terminal of the battery.

Install the piston of the 1st cylinder in the idle position. compression stroke